a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
6.
Remove the access panel.
7.
Remove the air baffle.
8.
Disconnect the iLO service port cable from the system board.
9.
If installed, disconnect the ODD cable.
10. Remove the LFF optical drive cage.
11. Use a flat-headed screwdriver to pry the fillers from box 1.
Hardware options installation
60