Removing An Expansion Slot Blank - HPE ProLiant DL180 Gen10 User Manual

Removing an expansion slot blank

Prerequisites
T-10 Torx screwdriver
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Remove the riser cage.
6. Remove the slot blank:
a. Press the latch on the slot blank retainer.
b. Open the slot blank retainer.
c. Remove one T-10 screw on the slot.
d. Remove the slot blank and retain it for future use.
34
Operations