Installing The Media Module Adapter - HPE ProLiant DL180 Gen10 User Manual

10. Install the FlexibleLOM riser cage.
11. Install the access panel.
12. Install the server into the rack.
13. Connect the LAN segment cables.
14. Connect all peripheral cables to the server.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server.
18. If removed, install the front bezel.
The installation is complete.

Installing the Media Module adapter

Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Do one of the following:
Hardware options installation
92