Table of Contents
Advertisement
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
Extend the server from the rack.
•
•
Remove the server from the rack.
4.
Remove the access panel.
5.
Install the chassis intrusion detection switch.
6.
Install the access panel.
7.
Install the server into the rack.
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10. Power up the server.
The installation is complete.
Installing a rear serial port interface
If a tertiary riser cage is installed, you can install the serial port into slot 6.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
Hardware options installation
138
Advertisement
Table of Contents
