Network Communication Setup; Automatically Setting Tcp/Ip Addresses - Xerox WorkCentre M20i System Administration Manual

Network Communication Setup

Automatically setting TCP/IP Addresses

At the WorkCentre M20i, perform these steps:
1 Ensure that the Ethernet Port has been configured (see "Ethernet Port" on page 2-3).
2 Press the [Machine Status] button.
3
4
5
Page 2-8
Press or until System
Admin Tools is displayed and
press [Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
Press or until Network
Setup is displayed and press
[Enter].
Press or until Configure
Network is displayed and press
[Enter].
System Admin Tools
[Passcode Protect]
System Admin Tools
[Network Setup]
Network Setup
[Config. Network]
Xerox WorkCentre M20i System Administration Guide