Network Setup - Xerox DocuCentre SC2020 User Manual

Tools

Network Setup

Use the [Network Setup] menu to change the device settings affecting jobs sent to the device through the
network.
Note: Bold values are the factory default menu settings.
Ethernet
Purpose: To confirm or specify network settings.
IP Mode
Purpose: To configure the IP mode.
Values:
Dual Stack
IPv4 Mode
IPv6 Mode
TCP/IP
Purpose: To configure TCP/IP settings.
Values:
Get IP Address DHCP/AutoIP
BOOTP
RARP
DHCP
Panel
IP Address
161 ®
Xerox DocuCentre
User Guide
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
Sets the IP address automatically. A random value in the
range of "169.254.1.0" to "169.254.254.255" that is not
currently in use on the network is set as the IP address.
The subnet mask is set as "255.255.0.0".
Sets the IP address using BOOTP.
Sets the IP address using RARP.
Sets the IP address using DHCP.
Use this option when you want to set the IP address
manually on the control panel.
When an IP address is being set manually, the IP is
allocated to the device using the format
"nnn.nnn.nnn.nnn". Each octet that makes up
"nnn.nnn.nnn.nnn" is a value in the range of "0" to "254".
"127" and any value in the range of "224" to "254" cannot
be specified for the first octet of a gateway address.
®
SC2020