Using Xerox Centreware Dp - Xerox WorkCentre M20i System Administration Manual

Using Xerox CentreWare DP

Installation Procedure
There are four stages required to install the WorkCentre M20i on a NetWare network using
Xerox CentreWare DP:
Network Communication Setup
Xerox CentreWare DP Setup
Install the printer driver on each workstation (see "Workstation Setup" on page 4-3)
Test Print
Network Communication Setup
At the WorkCentre M20i, perform these steps:
HINT:
WorkCentre M20i, refer to the Internet Services chapter for instructions.
1 Ensure that the Basic TCP/IP settings have been configured (see "Network
Communication Setup" on page 2-8).
2 Press the [Machine Status] button.
3
Xerox WorkCentre M20i System Administration Guide
This procedure will enable the WorkCentre M20i to communicate on the
NetWare network.
This procedure is used to complete the WorkCentre M20i installation using
Xerox CentreWare DP
A print job should be submitted to ensure the WorkCentre M20i has been
installed and configured correctly.
Xerox CentreWare Internet Services can also be used to configure the
Press or until System
Admin Tools is displayed and
press [Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
.
System Admin Tools
[Passcode Protect]
Page 3-5