Ethernet - Xerox WorkCentre M20i System Administration Manual

Ethernet

Use these instructions to set the rated speed for Ethernet using CentreWare Internet Services:
To complete the installation of the WorkCentre M20i, perform these steps:
1 Enable CentreWare Internet Services (see "Enabling Internet Services" on page 7-5).
2 At the CentreWare Internet Services Home Page for the WorkCentre M20i, select the
[Properties] tab.
3 Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
and then select the [+] symbol to the left of the Physical Connections folder.
4 In the Properties frame, within the Physical Connections folder, select [Ethernet].
Choose the appropriate [Rated Speed].
5
Click the [Apply] button to implement any changes.
6
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
Select the [Status] tab and then select [Reset Network Controller] to enable the
7
selection to take effect.
Xerox WorkCentre M20i System Administration Guide Page 7-7