Xerox WorkCentre M20i System Administration Manual page 100

6 Obtain and record the following information from the setup just completed. This
information is needed to configure the device with CentreWare Internet Services:
Continue with Configure the WorkCentre M20i.
7
Configure the WorkCentre M20i
To complete the installation of the WorkCentre M20i, perform these steps:
1 Enable CentreWare Internet Services (see "Enabling Internet Services" on page 7-5).
2 At the CentreWare Internet Services Home Page for the WorkCentre M20i, select the
[Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
3
and then select the [+] symbol to the left of the Protocols folder.
In the Properties frame, within the Physical Connections folder, select [NetWare].
4
Make the following selections and settings in the General section of the Protocols frame:
5
Select the checkbox to enable NetWare.
Choose the [Frame Type].
Set the [Queue Poll Interval].
This value determines how often the WorkCentre M20i polls the NetWare file server to
check if there is a file at the server to be printed or faxed. Enter a value from 10 to 240
seconds.
Enter the [Print Server] name. Use a meaningful name, such as the location of the
device.
NOTE: The Printer Server Name must match that entered using PConsole or the
NW Admin utility.
Page 7-12
File Server Name
Print Server Name
Print Server Password
Frame Type
Xerox WorkCentre M20i System Administration Guide