Xerox WorkCentre M20i System Administration Manual page 111

6 Select the [Status] tab and then select [Reset Network Controller] to enable the
selections to take effect.
Continue with Test Print.
7
Test Print
To ensure the device has been installed on the network correctly a test print should be
submitted from a client workstation. Perform the following steps:
Open a document on a client workstation.
1
Select the device as the printer to which the selected document will be sent.
2
Print the document on the device and verify that it prints correctly.
3
Make sure that the driver is installed on every workstation that will be sending jobs to the
4
device.
Repeat the test for all workstations that will be sending jobs to the device.
5
6 The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
Xerox WorkCentre M20i System Administration Guide Page 7-23