Enabling/Disabling LPR/LPD
This procedure is used to enable or disable Line Printer Remote/Line Printer Daemon (LPR/
LPD) port on the WorkCentre M20i. Once the port is enabled, you can change the LPR port
number.
To enable the LPR/LPD port, at the WorkCentre M20i, perform these steps:
Ensure that the basic TCP/IP settings have been made (see "Basic TCP/IP Settings" on
1
page 2-5).
2
Press the [Machine Status] button.
3
4
5
Xerox WorkCentre M20i System Administration Guide
Press
or
until System
Admin Tools is displayed and
press [Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
Press
or
until Network
Setup is displayed and press
[Enter].
Press
or
until Configure
Network is displayed and press
[Enter].
System Admin Tools
[Passcode Protect]
System Admin Tools
[Network Setup]
Network Setup
[Config. Network]
Page 6-3