Windows 2000 (Tcp/Ip) - Xerox WorkCentre M20i System Administration Manual

Windows 2000 (TCP/IP)

NOTE: Windows 2000 supports printing via TCP/IP as standard when TCP/IP is
installed on a Windows 2000 Workstation.
Use the Add Printer Wizard to add the WorkCentre M20i to the network.
Select [Start], select [Settings], and then select [Printers].
1
Double-click on the [Add Printer] icon to display the Add Printer Wizard.
Select [Local Printer], uncheck the box labelled [Automatically detect and install my
2
Plug and Play printer.]and then select [Next] to display the
ports.
3 Select [Create a new port] to display the Printer Ports
Select [Standard TCP/IP Port] and select [Next] to display the Add Standard TCP/IP Port
dialog
Enter the IP Address of the printer in the [Name or address of printer] field (you can
optionally enter a friendly name for the printer port you are creating or use the default
name created). Then select [Next] to continue.
If the network printer settings are not automatically detected, click on the [Custom] button
to setup the network printer port settings.
It is recommended that you select [RAW] as the Print Protocol.
If you prefer to use LPR:
Select [LPR] as the Print Protocol.
Enter [lp] (in lower case) in the [LPR print queue] field.
Uncheck the box labelled [LPR Byte Counting Enabled]
Check the box labelled [SNMP Status Enabled].
The [Community Name] should normally be set to "public" (unless you have configured
the device to have a custom SNMP community name) and the [SNMP Device Index]
should be set to 1.
Select [OK].
4 The Add Printer Wizard will then request that you select the driver to be used for this
printer.
Insert the CD ROM with the WorkCentre M20i drivers into the workstation and select
[Have Disk].
Page 4-6
box.
dialog
dialog box.
Xerox WorkCentre M20i System Administration Guide
box listing available