Using Netware Utilities - Xerox WorkCentre M20i System Administration Manual

Using NetWare Utilities

Installation Procedure
There are three stages required to install the WorkCentre M20i on a NetWare network using
NetWare utilities:
Network Communication Setup
NetWare Setup
Test Print
If running NLSP, ensure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre M20i.
Network Communication Setup
At the WorkCentre M20i, perform these steps:
HINT:
WorkCentre M20i, refer to the Internet Services chapter for instructions.
Ensure that the Basic TCP/IP settings have been configured (see "Network
1
Communication Setup" on page 2-8).
Press the [Machine Status] button.
2
3
Page 3-8
This procedure will enable the WorkCentre M20i to communicate on the
NetWare network.
This procedure is used to setup the network using NetWare utilities, for
example NWADMIN.
A print job should be submitted to ensure the WorkCentre M20i has been
installed and configured correctly.
Xerox CentreWare Internet Services can also be used to configure the
Press or until System
Admin Tools is displayed and
press [Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
Xerox WorkCentre M20i System Administration Guide