Xerox WorkCentre M20i System Administration Manual page 72

4
5
6
NOTE: The WorkCentre M20i will attach itself to the default zone of the local
segment where it is connected.
Install the Printer Driver (see "Printer Driver Installation (Mac OS 8x,9x only)" on page 5-5).
7
Page 5-4
Press or until Network
Setup is displayed and press
[Enter].
Press or until Configure
Network is displayed and press
[Enter].
Press or until Ethertalk
is displayed and press [Enter].
To enable or disable Ethertalk,
press or until the
desired setting, [On] or [Off] is
displayed and press [Enter].
System Admin Tools
[Network Setup]
Config. Network
[Ethertalk]
Ethertalk
[On]
Xerox WorkCentre M20i System Administration Guide