Xerox WorkCentre M20i System Administration Manual page 98

Test Print
To ensure the device has been installed on the network correctly a test print should be
submitted from a client workstation. Perform the following steps:
Open a document on a client workstation.
1
Select the WorkCentre M20i in the Chooser as the printer to which the selected document
2
will be sent.
Print the document on the device and verify that it prints correctly.
3
Ensure the driver is installed on every workstation that will be sending jobs to the
4
WorkCentre M20i.
Repeat the test for all workstations that will be sending jobs to the WorkCentre M20i.
5
The installation process is now complete.
6
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
Page 7-10 Xerox WorkCentre M20i System Administration Guide