Netware - Xerox WorkCentre M20i System Administration Manual
Xerox workcentre m20i: user guide
Hide thumbs
Also See for WorkCentre M20i:
- User manual (215 pages) ,
- Evaluator manual (16 pages) ,
- Brochure & specs (4 pages)
Table of Contents
Advertisement
NetWare
Use these instructions to install WorkCentre M20i on a NetWare network using CentreWare
Internet Services.
Installation Procedure
There are three stages required to install the WorkCentre M20i on a NetWare network using
CentreWare Internet Services:
PCONSOLE or NWADMIN Setup
Configure the WorkCentre M20i
Test Print
PCONSOLE or NWADMIN Setup
If running NLSP, be sure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre M20i.
Using the PCONSOLE or NWADMIN utility, perform the following steps:
Login to File Server as Supervisor or equivalent.
1
2
Create the Print Queue.
3
Create Print Server Name and Password.
4
Define the printer as Defined Elsewhere or Remote/Other Unknown.
5
Verify the Frame Type.
Xerox WorkCentre M20i System Administration Guide
This procedure is used to setup the network using NetWare's PCONSOLE or
NWADMIN utility.
This procedure explains how to use CentreWare Internet Services to
configure the WorkCentre M20i.
A print job should be submitted to ensure the device has been installed and
configured correctly.
Page 7-11
Advertisement
Table of Contents
