Enabling/Disabling HTTP
This procedure is used to enable or disable Hypertext Transfer Protocol (HTTP) on the
WorkCentre M20i.
To enable HTTP, at the WorkCentre M20i, perform these steps:
Ensure that the basic TCP/IP settings have been made (see "Basic TCP/IP Settings" on
1
page 2-5).
Press the [Machine Status] button.
2
3
4
5
Page 6-8
Press
or
until System
Admin Tools is displayed and
press [Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
Press
or
until Network
Setup is displayed and press
[Enter].
Press
or
until Configure
Network is displayed and press
[Enter].
System Admin Tools
[Passcode Protect]
System Admin Tools
[Network Setup]
Network Setup
[Config. Network]
Xerox WorkCentre M20i System Administration Guide