Ipx Ndps Printing - Xerox WorkCentre M20i System Administration Manual

IPX NDPS Printing

Ensure server(s) and NDS are patched to the correct level.
Ensure that NDPS 2.0 is installed.
Ensure that the latest version of the Xerox NDPS Gateway is installed on the relevant
server.
Ensure that you have an NDS login with sufficient rights to create objects in the desired
container.
NDPS Printing to the WorkCentre M20i can use either IPX or IP.
1
Before creating the new NDPS Printer the
printer server name an appropriate Netware Utility, for example NWAdmin.
NOTE: The correct tree and context are not required but it is necessary to enter
some text in each in order to save the print server name.
Create NDPS Printer object:
2
In NDS create a new NDPS Printer object in the appropriate container:
3 Install the print driver for on each workstation (see "Workstation Setup" on page 4-3).
Xerox WorkCentre M20i System Administration Guide
- Enter a name and select [Create].
- Choose the appropriate NDPS Manager and select the Xerox Printer Gateway.
Select [OK].
- In Select a Network Protocol choose [IPX] and select [OK] and then [Next] to
launch the Installation Wizard.
- From the list select the print server name created in Step 1. Ensure that Auto
Create NDS Objects is checked, then select [Next] and [Next] again.
- Select [Finish]. The WorkCentre M20i will reset and the new Printer Agent will
load on the relevant server.
- You can select print drivers if you wish. Select [Continue] and then [OK] to
finish.
WorkCentre M20i
must be configured with a
Page 3-11