Tcp/Ip - Xerox WorkCentre M20i System Administration Manual

TCP/IP

Use these instructions to install the device on a TCP/IP network using CentreWare Internet
Services.
Installation Procedure
There are two stages required to install the device on a TCP/IP network using CentreWare
Internet Services:
Configure the WorkCentre M20i
Test Print
Configure the WorkCentre M20i
NOTE: The TCP/IP settings for the device will have been setup when completing
the Enabling CentreWare Internet Services section.
To complete the installation of the device, perform these steps:
1 Enable CentreWare Internet Services (see "Enabling Internet Services" on page 7-5).
2 At the CentreWare Internet Services Home Page for the WorkCentre M20i, select the
[Properties] tab.
3 Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
and then select the [+] symbol to the left of the Protocols folder.
4 Select [TCP/IP] and check the Protocol Configuration details are correct. If any of the
details are incorrect then enter the correct information.
5 In the Physical Connection field, Ethernet will be the default setting.
Page 7-14
This procedure explains how to use CentreWare Internet Services to
configure the device.
A print job should be submitted to ensure the device has been installed and
configured correctly.
Select the checkbox to enable TCP/IP.
Enter the [Host Name].
Choose the [IP Address Resolution] required.
Xerox WorkCentre M20i System Administration Guide