6 6
7
8
9
NOTE: While you can change the port number at which the WorkCentre M20i will
accept LPR print jobs, it is recommended that you do this ONLY with extreme
caution as most LPR spoolers are set to send print jobs to the default port number,
515.
Page 6-4
Press
or
until TCP/IP is
displayed and press [Enter].
Press
or
until Manual is
displayed and press [Enter].
Press
or
until LPD/LPD
is displayed and press [Enter].
To enable or disable LPD/LPD,
press
or
until the
desired setting, [Enable] or
[Disable] is displayed, enter the
port number using the keyboard
and press [Enter].
Config Network
[TCP/IP]
TCP/IP
[Manual]
Manual
[LPD/LPD]
LPD/LPD
[Enable]
Xerox WorkCentre M20i System Administration Guide