Manually Setting Tcp/Ip Addresses - Xerox WorkCentre M20i System Administration Manual

Manually setting TCP/IP Addresses

At the WorkCentre M20i, perform these steps:
HINT:
WorkCentre M20i, refer to the Internet Services chapter for instructions.
When manually making the TCP/IP settings, you will need to know the following information:
The IP address.
The subnet mask, if required.
The Gateway address, if required
The primary and Secondary DNS address, if required.
Ensure that the Ethernet Port has been configured (see "Ethernet Port" on page 2-3).
1
Press the [Machine Status] button.
2
3
4
Page 2-10
Xerox CentreWare Internet Services can also be used to configure the
Press or until System
Admin Tools is displayed and
press [Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
Press or until Network
Setup is displayed and press
[Enter].
System Admin Tools
[Passcode Protect]
System Admin Tools
[Network Setup]
Xerox WorkCentre M20i System Administration Guide