Agilent Technologies 1100 Series User Manual page 194

10 Control Module Screens
Built-in Test Chromatogram (Simulation)
To start the built-in test chromatogram, use the F8 key (Execute) to enable the
simulation. Select Start to start a run (all modules in the Agilent 1100 system
must be in ready state).
Use the F6 key (Plot) to view the signal. A simulated chromatogram (4 peaks)
will repeat until the run is stopped. The signal is also available on the analog
output. A change of the peak width will change the retention times.
194 1100 Series DAD and MWD User Manual