How To Check The Action Of Total Pulses - Fuji Electric FLR-3 Instruction Manual

4.11.3. How to check the action of total pulses

Description
 Checks the action of total pulse output.
The output action can be checked upon designating the number of pulses to be outputted per second.
Settable range: 1 to 100 pulses/s (when pulse width is 5ms, 10ms,50ms, 100ms or 200ms)
Note 1) The output pulse width is as selected currently. (See 4.9.2.1.)
Set the frequency taking the pulse width into account referring to the following expression.
The number of setting pulses  1000/(Pulse width[ms] × 2)
Example: If the pulse width is set to 50ms, select 10 pulses/s or less.
Note 2) When pulse width is 500ms and 1000ms, output action is performed at the rate of 1pulse/4seconds regardless of setting.
Note3) Before checking the action, confirm whether proceeding to an action is permitted.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Perform pulse output of 5 pulses/s.
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Note) Start simulated pulse output.
Press the
▼
Press the
▼
Press the
ENT
▼
▼
▼
▼
5 PULSE/s simulated pulse is output.
ESC After checking the output, press the
▼
pulse output.
ESC Press the
measurement mode.
INF-TN3FLR-E
Description
key for 4 times to display "MAINTENANCE MODE".
key once to display "RAS INFORMATION".
ENT
key for 3 times to display "TOTAL PULSE".
key once to blink the cursor.
ENT
key twice to move the cursor.
key for 4 times to set "5".
key once to register.
ENT
――― 5 PULSE/s has been registered. ―――
ESC
ESC key once and then press the
key once to stop simulated
key once to enter the
Display
MAINTENANCE MODE
RAS INFORMATION
0000000000000000
TOTAL PULSE
1 PULSE/s
TOTAL PULSE
001 PULSE/s
TOTAL PULSE
001 PULSE/s
TOTAL PULSE
005 PULSE/s
TOTAL PULSE
 COMPLETE 
↓
TOTAL PULSE
005 PULSE/s
TOTAL PULSE
005 PULSE/s
0.000 %
0.000 m3
- 63 -