Table of Contents
Advertisement
4.11.10. LCD backlight setting
Description
Sets the operation of the LCD backlight.
You can set that light is ON all the time/ light is OFF all the time/ light is ON only when key operation and light is OFF at setting time.
Setting content
ON: LCD backlight is ON all the time.
OFF: LCD backlight is OFF all the time
Lights-out time: sets the time for backlight to put out.
When OFF is set, this function is enabled. [setting range: 0 to 99min]
When you set the setting time to 0 min, backlight is OFF all the time.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation
Set the backlight ON time to 10minuites after key operation is completed.
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
ENT
Press the
▼
Set "10" by the
▼
ENT
Press the
▼
▼
Display the measurement mode by the
ESC
INF-TN3FLR-E
Description
key for 4 times to display "MAINTENANCE MODE".
key once to display "RAS INFORMATION".
ENT
key for 11 times to display "LCD BACKLIGHT"
key once to blink the cursor.
ENT
key once to select "OFF"
key once to register "OFF"
ENT
key once to blink the cursor on line2.
ENT
and the
key.
key once to register.
ENT
――― LCD BACKLIGHT has been registed ―――
key and the
key.
ESC
Display
MAINTENANCE MODE
RAS INFORMATION
0000000000000000
LCD BACKLIGHT
LCD BACKLIGHT
LCD BACKLIGHT
LCD BACKLIGHT
↓
LIGHT-OFF TIME
LIGHT-OFF TIME
LIGHT-OFF TIME
0.000
m/s
0.000
m3/h
ON
ON
OFF
OFF
05min
10min
10min
- 71 -
Advertisement
Table of Contents
