Setting Of Alarm Value - Fuji Electric FE ZSS Instruction Manual

Alarm Setting
H - Limit
L-Limit
Hysteresis
Analog Output
Alarm Record
Alarm Setting
H - Limit
L-Limit
Hysteresis
Analog Output
Alarm Record

6.3.2 Setting of alarm value

Make a setting of the High/Low limit alarm for the measured concentration. To change the alarm setting, set
the Alarm ON/OFF setting to ON, and then change the numeric value.
Note
Point the to "H-Limit" to change the setting of H-Limit value, and point "L-Limit" to change the set-
ting of the L-Limit value.
Alarm Setting
H - Limit
L-Limit
Hysteresis
Analog Output
Alarm Record
50.00 ppm
Range1
Range2 30.00 ppm
ON
10.00 ppm
Range1
00.00 ppm
Range2
15
%FS
Range2 H- Limit
( ) NT
50.00 ppm
Range1
30.00 ppm
Range2
OFF
10.00 ppm
Range1
00.00 ppm
Range2
15 %FS
Range2 H- Limit
50.00
Range1 ppm
30.00 ppm
Range2
OFF
10.00
Range1 ppm
00.00
Range2 ppm
15 %FS
Range2 H- Limit
( )
Select "ON" or "OFF" by the
key, and press the
When "OFF" is selected, the cursor returns to the
"H-Limit". When "ON" is selected, the
moves to "Range1" of H-Limit or L-Limit, and
set the alarm value. For setting of the alarm val-
ues, refer to "6.3.2 Setting of alarm value".
Point the to "H-Limit" to set the H-limit
value, and point "L-Limit" to set the L-Limit
value, and then press the
- 40 -
key or the
key.
key.
INZ-TN1ZSS-E