Initializing Setting Parameters - Fuji Electric FLR-3 Instruction Manual

4.11.9. Initializing setting parameters

Description
 Initializes the setting parameters saved in the memory.
 Initializes those other than the zero adjusted values or analog output calibration value.
Initialize code: 0100 (4-digit number)
 This parameter is intended for our service personnel.
 Do not attempt to initialize the setting parameters. Otherwise measurement is disabled.
When the parameter is initialized, display language is set to English.
To switch the display language, refer to "4.5. Display language".
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Initializes the setting parameters.
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Set "0100" by the
▼
Press the
ENT
▼
▼
― Flow transmitter is reset, and the measurement mode is displayed. ―
▼
- 70 -
Description
key for 4 times to display "MAINTENANCE MODE".
key once to display "RAS INFORMATION".
ENT
key for 10 times to display "MEMORY INITIAL".
key twice to blink on the 2nd line.
ENT
and the key.
key once to register.
ENT
AUTION
Display
MAINTENANCE MODE
RAS INFORMATION
0000000000000000
MEMORY INITIAL
MEMORY INITIAL
MEMORY INITIAL
MEMORY INITIAL
 COMPLETE 
↓
0.000 m/s
0.000 m3/h
INF-TN3FLR-E
0000
0100