Setting The Lcd Indication - Fuji Electric FLR-3 Instruction Manual

4.9.4. Setting the LCD indication

Description
 Flow velocity indication
Selectable flow velocity units: m/s (if SYSTEM UNIT was set to METRIC) (See 4.8.1)
<Note> The decimal point position is fixed. (Decimal point 3 digits)
 Flow rate indication
Selectable flow rate indications: Actual value reading, % reading.
<Note> The indication unit is as selected by FLOW UNIT. (See 4.8.2.)
 Total indication
Selectable total indications: Actual total value reading (forward/reverse flow), total pulse count (forward/reverse flow).
<Note> The indication unit is as selected by TOTAL UNIT. (See 4.8.3.)
 How to validate the indication
Set the DISPLAY setting mode to 1st ROW (for indication on 1st line) or 2nd ROW (for indication on 2nd line), and further select
indication contents.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Display the 1st line of LCD indication in percentages (%).
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
"1:DECIMAL POINT".
Press the
▼
Press the
ENT
▼
▼
――― FLOW RATE(%) indication has been set. ―――
▼
▼
Press the
ESC
the measurement mode.
INF-TN3FLR-E
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key for 3 times to display "DISPLAY".
key once to blink the cursor.
ENT
key again, and select "1ST LOW".
ENT
key twice to display "FLOW RATE(%)".
key once, and select and fix "FLOW RATE(%)" to display
ENT
key once to shift the decimal point position to next place.
key once to register.
ENT
key twice and then press the
ESC
OUTPUT SETUP
ZERO ADJUSTMENT
DISPLAY
DISPLAY
1ST LOW
1ST LOW
1:DECIMAL POINT
 . 
1:DECIMAL POINT
 . 
1:DECIMAL POINT
1:DECIMAL POINT
 . 
key for 3 times to enter
Display
SET ZERO
DISPLAY 1
DISPLAY 1
VELOCITY
FLOW RATE(%)
 COMPLETE 
↓
0.00 %
0.000 m3
- 41 -