Disassembly Of The Rear Brake Master Control - Ducati 1098 2007 Manual

section
F 4

Disassembly of the rear brake master control

The brake master cylinder is supplied only as a complete unit; internal components cannot be replaced.
To disassemble the external parts of master cylinder assembly, refer to the exploded view at the beginning of this chapter.
If the bush (10) inside the brake pedal (6) needs to be renewed, drive the replacement bush into place using a press. The bush
must be seated 2 mm below the outer face of the pedal.
To disassemble the various parts of the system, refer to the exploded view at the beginning of this chapter.
Warning
After working on the rear brake control, check the operation of the brake pedal as described in Sect. D 4.
WWW.PlanDeGraissage.ORG
1098/1098S - M.Y. 2007 - edition 00
Controls - Devices
6
10
A
B
C
D
E
F
G
H
L
M
N
P
21