Establishing A Wifi Connection - Viavi CX100 ComXpert Operation Manual

4.4.2 Establishing a WiFi Connection

The WiFi option allows the device to be connection to a wireless network to export reports,
screen shots, or job tickets (using FTP), or update the device's firmware.
NOTE
The CX100 supports 2.4 GHz and 5 GHz WiFi.
4.4.2.1 Adding a WiFi Network Profile
The CX100 can save up to 32 WiFi network profiles. If an access point does not broadcast
a Service Set Identifier (SSID), a WiFi profile can be created manually. The device will save
the profile, then automatically authenticate and establish a connection to the network when
the following conditions are met:
• Network connectivity is enabled.
•
The network's access point is in range.
• The network is determined to provide the best available access point (based on
signal strength and/or encryption supported).
NOTE
The CX100 automatically saves a WiFi network profile after successfully connecting to
the WiFi network.
To Add a WiFi Network Profile
1. Enable network connectivity on the CX100.
Connectivity", on page 4-10
2. Navigate to the
Network menu appears.
3. Select the
for WiFi networks and lists each network as an item.
4. Select
5.
Specify the following settings:
Setting
SSID
Password
22144015
August 2023
for information.
Network panel
WiFi button located on the soft-key panel. The device immediately scans
Add Network. The Add WiFi Network controls and settings are displayed.
Value
The SSID (Service Set Identifier) of the WiFi network.
The password required to authenticate to the network.
A password is not required if Key Management is set to None.
CX100 ComXpert Operation Manual
See section 4.4.1.1, "Enable Network
(System button > Network button). The System
Chapter 4 Configuring System Settings
Establishing a Network Connection
Rev 002
4 - 13