Remote Operation Panel - Viavi CX100 ComXpert Operation Manual

3.1.3 Remote Operation Panel

Remote operation settings are used to configure the device for remote operation.
section 4.5, "Remotely Operating the Device", on page 4-16
for configuring the device for remote operation.
The VNC parameters are used to configure the device for remote access and operation.
See section 4.5.1, "Establishing VNC Viewer Connection", on page 4-16
configure the device for remote operation.
Control/Setting
Enable HTTP File Server
Enable VNC Server
VNC Password
Connected Viewers
Reserve Ethernet Port
for Remote Access
22144015
August 2023
Table 3-2 Remote Operation and VNC Controls and Settings
Description
When this check box is selected, files can be
downloaded from the CX100 via a web browser.
See section 7.2.5, "Downloading Files via Web
Browser", on page 7-6
This tick box must be selected in order to access the
device using a remote UI viewing application.
This field defines a password that will be required when
accessing the device remotely using VNC viewing
application.
This indicates how many users are remotely connected
to the device.
This check box enables simultaneous usage of System
Network access and Data Test access on the CX100's
Ethernet connectors.
System Network access will use Ethernet 1 Connector;
Data Testing will use Ethernet 2 Connector. If this option
is not selected, either connector can be used for
System Network Access.
CX100 ComXpert Operation Manual
Chapter 3 System and Utility Function Descriptions
for step by step instructions
for instructions to
for instructions.
Introduction
See
Rev 002
3 - 5