Chapter 6 Performing Tests and Measurements
CX100 Self Test Procedure
6.1
CX100 Self Test Procedure
6.1.1 Scope of Test
The following procedure runs the CX100 automated self-test procedure.
NOTE
Self Test is intended to verify the device is operating properly; Self Test does not verify
that the device is operating to performance specifications.
6.1.2 Equipment Needed
An external audio cable is required for the audio loopback test.
6.1.3 Running Self-test
To Run the Self Test Procedure
1.
Power on the CX100.
2.
Expand RF Instrument tab on the CX100.
3.
Press the
4.
Select
5.
Press the
6.
Press the
7.
Wait while the device performs a series of automated test process. Do not interrupt
this process or the self test will fail.
8.
Status indicators show when self test is finished.
Rev 002
6 - 2
AutoTest
button to open the AutoTest application.
Self Test
from the test list.
Select All
soft-key.
Run Selected
soft-key.
CX100 ComXpert Operation Manual
22144015
August 2023