Screen & Power Management; Sounds Screen; Theme - Viavi CX100 ComXpert Operation Manual

Chapter 3 System and Utility Function Descriptions
Introduction
3.1.17 Screen & Power Management
The Screen & Power Management Screen contains settings that adjust the brightness
of the LED backlight, the backlight timeout and the battery saver timeout.
4.2.5, "Configure Device Power Settings", on page 4-7
NOTES
"Idle time" refers to time during which no keys are pressed and no line activity takes
place. If the Power Off Delay is set to 5 minutes and a 15 minute test is started, the
unit will not power down during the test because there is activity on the line (as a result
of the test).
Battery Saving Mode is not applicable when the device is connected to an AC power
supply.
Setting
Backlight
Backlight
Timeout
Power Off Delay

3.1.18 Sounds Screen

The Sounds panel contains settings that configure the device to emit a chime when the
Power button is pressed to turn the device on or off.
Up/Down", on page 4-7

3.1.19 Theme

The UI Theme panel contains settings that allow users to change the color scheme of the
UI. Changes take effect immediately; the device does not need to be rebooted to apply
selection.
Rev 002
3 - 12
Table 3-10 Screen and Power Management Settings
Description
This setting adjusts the brightness setting of the LED's
backlight.
This setting defines the amount of time the device can remain
idle before the LED's backlight turns off.
The Power Off Delay setting defines how long the instrument
remains idle before the instrument automatically powers itself
off when operating on battery power.
for information.
CX100 ComXpert Operation Manual
See section
for procedures.
See section 4.2.5.2, "Beep at Power
22144015
August 2023