Viavi CX100 ComXpert Operation Manual page 262

NOTE
If module sticks to the Base, insert a screw driver where shown and gently pry until
module releases (see
5.
Place the OneExpert Base on an ESD work surface with the display side down.
CAUTION
To avoid damaging hardware, do not place pressure against the Base PCB Assemblies.
1
NOTE
If the RF Module is being returned to the factory.
Instructions", on page 8-2
22144015
August 2023
Figure B-2).
Figure B-2 Separating RF Module and Base
Figure B-3 Base Unit - RF Module Removed
for shipping instructions.
CX100 ComXpert Operation Manual
Appendix B Module and Battery Replacement Procedures
See section 8.4, "Shipping
Removing the RF Module
Rev 002
B - 5