Chapter 2 Getting Started: Setup and Operation
Upon Receipt
2.1
Upon Receipt
The following tasks should be performed when a CX100 is received from the factory:
•
Unpack the Equipment
•
Inspect the Equipment
•
Verify Contents
•
Prepare for First Time Use
•
Verify Operation
2.1.1 Unpack the Equipment
NOTE
When unpacking the device, use care not to damage the shipping container and
packaging materials: materials should be stored for possible future use.
The CX100 battery is a lithium battery that is shipped in special protective packaging.
When removing the packaging, use care not to damage the packaging; the protective
packaging can be used in the event the battery needs to be shipped.
To Unpack the Device
1.
Cut and remove sealing tape from the top of the shipping container.
2.
Remove foam inserts and equipment from the shipping container.
3.
Remove the CX100 and battery from packing materials.
4.
Store packing material and shipping container for possible future use.
2.1.2 Inspect the Equipment
Inspect the equipment for any damage which may have occurred during shipment. Report
any damage to VIAVI (see
Rev 002
2 - 2
"Contact Information" on page
CX100 ComXpert Operation Manual
1-iii).
22144015
August 2023