Viavi CX100 ComXpert Operation Manual page 126

5.2.7.2 Meter Soft-key Panel
The contents of the Meter soft-key panel is determined by the selected meter group. To
activate a soft-key panel, select the group title bar (e.g. Audio Measurements or Transmit
Measurements). The contents of the soft-key panel will update to display soft-keys that
support functions applicable to the selected meter group.
5.2.7.3 Meter Configuration Window
Each meter requires specific controls and settings necessary to configure how
measurements are performed and how the results are displayed on the UI. These controls
and settings are located in meter configuration windows. Meter configuration windows are
opened by pressing and holding a meter block.
The contents of meter configuration windows varies according to the settings required to
perform each measurement. This section describes meter limits and measurement type
settings, which are supported in some capacity on each meter. Other meter parameters
are described in the following sections:
• 5.2.7.4 Audio Measurements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-20
• 5.2.7.5 Analog Demod Measurements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-21
• 5.2.7.6 Digital Demod Measurements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-23
• 5.2.7.7 Transmit Measurements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-29
22144015
August 2023
Select block to open
Meter Configuration
Window.
Figure 5-4 Opening Meter Configuration Window
CX100 ComXpert Operation Manual
Chapter 5 RF Instrument Function Descriptions
RF Test
Rev 002
5 - 17