Table of Contents
Advertisement
The AC Current Icon is displayed at the top of the UI when the device is connected to
an AC power supply.
2.2.2 Battery Operation
The CX100 is designed to be powered by an internal battery that supports up to 3 hours
of continuous operation. The amount of battery operation time remaining is indicated by
the Battery LED on the front panel.
information.
The CX100 is designed with a time-out feature which conserves battery power; this feature
is referred to as "Battery Saving Mode". The time-out period is defined on the Screen and
Power Settings panel.
information.
To Charge the Battery
1.
Connect the device to an AC power supply.
2.
Verify the device's Battery LED turns amber to indicate the battery is charging.
3.
The Battery LED turns green when the battery is fully charged.
2.3
Power On/Off Procedures
The CX100 is powered on and off using the Power button located on the front panel.
NOTE
The CX100 can be configured to emit a beep at power up/power down.
4.2.5.2, "Beep at Power Up/Down", on page 4-7
2.3.1 Turning the Device ON
1.
Press and release the Power button.
2.
An initializing indicator is displayed during the boot-up process. Wait while the device
completes the boot-up process; this takes several seconds.
3.
The Home screen is displayed when the device is ready for use.
22144015
August 2023
See section 1.6.4, "Battery LED", on page 1-13
See section 4.2.5.1, "Battery Saving Mode", on page 4-7
CX100 ComXpert Operation Manual
Chapter 2 Getting Started: Setup and Operation
Power On/Off Procedures
for information.
for
for
See section
Rev 002
2 - 7
Advertisement
Table of Contents
Troubleshooting
