Table of Contents
Advertisement
Chapter 4 Configuring System Settings
Hardware/Software Versions and Options
4.8
Hardware/Software Versions and Options
4.8.1 Viewing Hardware/Software Revision Information
To View Hardware Revision Information
1.
Navigate to the System Settings menu.
2.
Select the Hardware/Software Revisions button. The revisions of the internal
components and the software versions is displayed.
4.8.2 Viewing Option Information
To View Hardware or Software Revision Information
1.
Navigate to the System Settings menu.
2.
Select the Software Options button or Hardware Options button.
A list of available options appears with the status for each option.
•
•
4.8.3 Installing Options
This section contains instructions for installing options on the device.
To Install Options from USB
1.
Before installing options, upgrade the device to the latest firmware.
"Updating the Device's Software", on page 4-18
2.
Copy the option file to a USB device.
3.
Connect the USB device to one of the CX100's USB connectors.
NOTE
If performing a CD update, connect the USB to CD-ROM device to one of the CX100's
USB connectors and insert software CD in the CD-ROM.
4.
Navigate to the Software Options panel (System Settings > Software Options).
5.
Select the Import from USB soft-key.
6.
Select the desired firmware file on the USB drive.
7.
Press the Update button to start the upgrade. At prompt, confirm the update.
8.
Reboot the device. The option is installed.
Rev 002
4 - 20
Enabled: option has been enabled on the device.
Upgradeable: option has not yet been purchased/enabled on the device.
CX100 ComXpert Operation Manual
See section 4.7,
for information.
22144015
August 2023
Advertisement
Table of Contents
Troubleshooting
