Ignition Switch Inspection; Ignition Switch Removal And Installation; Specifications; Service Data - Suzuki RMX450Z Service Manual

9C-6 Combination Meter / Fuel Meter / Horn:

Ignition Switch Inspection

Inspect the ignition switch in the following procedures:
1) Remove the headlight cover. Refer to "Headlight
Removal and Installation" in Section 9B (Page 9B-2).
2) Disconnect the ignition switch coupler (1).

Service Data

Wattage
Unit: W
Item
Fuel indicator light

Tightening Torque Specifications

NOTE
The specified tightening torque is described in the following.
"Speedometer Construction" (Page 9C-2)
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List" in Section 0C
(Page 0C-8).

Special Tool

09900–25008
Multi circuit tester set
(Page 9C-4) / (Page 9C-
6)
BA02J29306010
1

Ignition Switch Removal and Installation

IA02J1930009-01
Refer to "Ignition Switch Removal and Installation" in
Section 1H (Page 1H-9).

Specifications

Special Tools and Equipment

3) Inspect the ignition switch for continuity with the
tester. If any abnormality is found, replace the
ignition switch with a new one.
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity ( )
Color
R
Position
ON
OFF
4) After finishing the ignition switch inspection, reinstall
the removed parts.
Specification
12 V 3.4 W
Br R/B B
IA02J1930011-01
BA02J29306011
BA02J29307001
BA02J29307002
BA02J29308001