Specifications; Service Data; Tightening Torque Specifications - Suzuki RMX450Z Service Manual

2) Stake the joint pin by turning (approximately 7/8 turn)
the pressure bolt [A] (3) with the bar until the pin end
diameter becomes the specified dimension.
CAUTION
!
• After joining of the chain has been
completed, check to make sure that the
link is smooth and no abnormal condition
is found.
• Should any abnormal condition be found,
reassemble the chain link using the new
joint parts.
Pin end diameter specification "a"
DID: 5.5 – 5.8 mm (0.22 – 0.23 in)

Service Data

Drive Train
Unit: mm (in) Except ratio
Item
Final reduction ratio
Drive chain
Drive chain plate height
Drive chain slack

Tightening Torque Specifications

Fastening part
Engine sprocket cover bolt
Rear sprocket nut
NOTE
The specified tightening torque is described in the following.
"Drive Chain Related Components" (Page 3A-2)
"Drive Chain Roller Construction" (Page 3A-3)
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List" in Section 0C
(Page 0C-8).
3) Adjust the drive chain slack, after connecting it.
Refer to "Drive Chain Inspection and Adjustment" in
Section 0B (Page 0B-20).

Specifications

Standard
3.923 (51/13)
Type
Links
Inner
Outer
40 – 50 (1.6 – 2.0)
Tightening torque
N⋅m
11
30
Drive Chain / Drive Train / Drive Shaft:
DID 520MXV
114 links
15.0 (0.59)
12.8 (0.50)
kgf-m lbf-ft
1.1 8.0
3.0 21.5
3A-9
3
I649G1310035-02
"a"
I649G1310036-03
BA02J23107001
Limit
—
—
—
12.75 (0.502)
11.20 (0.441)
—
BA02J23107002
Note
(Page 3A-4)
(Page 3A-5)