Suzuki RMX450Z Service Manual page 338

2C-22 Rear Suspension:
Installation
Install the swingarm in the reverse order of removal. Pay
attention to the following points:
CAUTION
!
The removed oil seals and dust seals must
be replaced with new ones.
• Apply grease to the dust seals, bearings and oil seals.
: Grease 99000–25010 (SUZUKI SUPER
GREASE "A" or equivalent)
• Install the following parts into the swingarm.
– Oil seal (1)
– Spacer (2)
– Washer (3)
– Thrust bearing (4)
– Washer (5)
– Dust seal (6)
– Spacer (7)
3 3
4
6
7
• Install the plate.
NOTE
When reusing the removed screw (8), apply a
small quantity of the thread lock to them.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER "1322" or
equivalent)
IA02J1230086-01
2
5
1
IA02J1230087-01
• Install the swingarm.
• Tighten the swingarm pivot nut (9) to the specified
torque.
Tightening torque
Swingarm pivot nut (a): 70 N·m (7.0 kgf-m, 50.5
lbf-ft)
• Install the rear brake caliper (10) to the swing arm.
• Install the rear brake master cylinder. Refer to "Rear
Brake Master Cylinder Assembly Removal and
Installation" in Section 4A (Page 4A-12).
8
IA02J1230088-01
9
(a)
IA02J1230089-01
10
IA02J1230090-01