Suzuki RMX450Z Service Manual page 464

9A-4 Wiring Systems:
"E"
"F"
1
"B"
1. Clamp
: Clamp the lead wire at tube part of the lead wire and set the tip of clamp right
side.
2. Fuel pump couler
: Set the fuel pump coupler over the throttle body.
"A": Pass the high tension code between the throttle cable and clutch cable.
"B": Pass the lead wires and couplers over the intake pipe. Do not contact the lead
wires and couplers to the cylinder head.
"C": Pass the tail light lead wire coupler over the rear fender. Do not pinch the
coupler between the air cleaner box and seat rail.
"A"
" a "
2
"D"
"D": Face the fuse box over the lead wire and clamp the lead wire
with the clamp.
"E": Do not route the TO sensor lead wire too tight.
"F": Pass the gear position switch lead wire under the TO sensor
lead wire.
"G": Tighten the battery (+) and (–) lead wires from the top side.
"a": 90°
"G"
"C"
IA02J1910911-05