Rear Suspension Inspection; Rear Shock Absorber Inspection - Suzuki RMX450Z Service Manual

2C-10 Rear Suspension:
Bearing / Dust Seal
1) Press the new needle roller bearing cage with the
special tool and a suitable size socket wrench.
NOTE
When installing the needle roller bearing
cage, the stamped mark on the bearing must
left side.
Special tool
(A): 09924–84521 (Bearing installer set)
(A)
2) Press the new dust seals with the special tool and a
suitable size socket wrench.
NOTE
When installing the dust seal, the stamped
mark "A" on the dust seal must face inside.
Special tool
(A): 09924–84521 (Bearing installer set)
"A"
3) Apply grease to the needle roller bearings and install
them.
4) Apply grease to the dust seals and spacers.
5) Install the spacers (1) (right side) and (2) (left side).
GREASE "A" or equivalent)

Rear Suspension Inspection

Refer to "Rear Suspension Inspection" in Section 0B
(Page 0B-24).

Rear Shock Absorber Inspection

IA02J1230030-01
Refer to "Rear Shock Absorber Disassembly" (Page 2C-
6) and "Rear Shock Absorber Assembly" (Page 2C-8).
Rear Shock Absorber
Inspect the rear shock absorber for damage and oil
leakage. If any defects are found, replace the defective
parts with a new one.
(A)
IA02J1230031-01
: Grease 99000–25010 (SUZUKI SUPER
2
1
IA02J1230032-01
BA02J22306008
BA02J22306009
IA02J1230033-01