Use Of Sds Diagnosis Reset Procedures - Suzuki RMX450Z Service Manual

Use of SDS Diagnosis Reset Procedures

NOTE
The malfunction code is memorized in the
ECM also when the wire coupler of any
sensor is disconnected. Therefore, when a
wire coupler has been disconnected at the
time of diagnosis, erase the stored
malfunction history code using SDS.
1) After repairing the trouble, turn OFF the ignition
switch and turn ON again.
2) Click the DTC inspection button (1).
3) Check the DTC.
4) The previous malfunction history code (Past DTC)
still remains stored in the ECM. Therefore, erase the
history code memorized in the ECM using SDS tool.
5) Click "Clear" (2) to delete history code (Past DTC).
Engine General Information and Diagnosis:
6) Follow the displayed instructions.
BA02J21104003
1
7) Check that both "Current DTC" (3) and "Past DTC"
IA02J1110089-01
8) Close the SDS tool and turn the ignition switch OFF.
9) Disconnect the SDS tool and install the left side
2
I705H1110005-01
(4) are deleted (NIL).
cover.
1A-12
I705H1110006-01
I705H1110009-01
3 4
I705H1110008-01