Swingarm Removal And Installation - Suzuki RMX450Z Service Manual

2C-20 Rear Suspension:
3) Install the dust seals with the special tool.
Special tool
(B): 09913–70210 (Bearing installing set (10
– 75 Φ))
4) Apply grease to the bearings and dust seal lips.
: Grease 99000–25010 (SUZUKI SUPER
GREASE "A" or equivalent)
5) Install the cushion rod. Refer to "Cushion Rod
Bearing Removal and Installation" (Page 2C-19).

Swingarm Removal and Installation

Removal
CAUTION
!
Make sure that the motorcycle is supported
securely.
1) Remove the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation" in
Section 2D (Page 2D-11).
(B)
IA02J1230101-01
IA02J1230077-01
BA02J22306018
2) Remove the chain guide (1).
1
3) Remove the rear master cylinder mounting bolts and
brake hose guide bolt.
4) Remove the rear brake caliper (2) from the swing
arm.
2
5) Remove the cushion rod bolt and nut.
6) Remove the cushion lever bolt and nut.
7) Remove the rear shock absorber mounting bolt and
nut.
IA02J1230078-01
IA02J1230079-01
IA02J1230080-01