Fuel Discharge Amount Inspection
WARNING
!
• Keep away from fire or spark.
• Spilled gasoline should be wiped off
immediately.
• Work in a well-ventilated area.
Inspect the fuel discharge amount in the following
procedures:
1) Remove the fuel tank bolt and unhook the rubber
band. Refer to "Fuel Tank Removal and Installation"
(Page 1G-5).
2) Place a rag under the fuel feed hose (1) and
disconnect fuel feed hose (1) from the fuel pump.
3) Disconnect the fuel pump lead wire coupler (2).
1
4) Connect a proper hose (3) to the fuel pump.
5) Place a measuring cylinder and insert the hose end
into the measuring cylinder.
3
6) Connect proper lead wires to the fuel pump lead wire
BA02J21706003
7) After finishing the fuel discharge inspection, reinstall
2
IA02J1170003-01
Fuel Pump Relay Inspection
Refer to "DTC "41" (P0230): FP Relay Circuit
Malfunction" in Section 1A (Page 1A-65).
Fuel Hose Inspection
Refer to "Fuel Hose Inspection" in Section 0B (Page 0B-
14).
Fuel Level Indicator Inspection
Refer to "Speed Sensor Inspection" in Section 9C
(Page 9C-4).
IA02J1170004-03
coupler (fuel pump side) and apply 12 V to the fuel
pump (between (+) R wire and (–) B wire) for 10
seconds and measure the amount of fuel
discharged.
NOTE
The battery must be in fully charged
condition.
Fuel discharge amount
Approx. 240 ml (8.1/8.4 US/Imp oz) /10 sec.
the removed parts.
NOTE
Connect the fuel feed hose to the fuel pump
until it locks securely (a click is heard).
Fuel System:
1G-4
IA02J1170005-01
BA02J21706004
BA02J21706005
BA02J21706006