Rear Wheel Related Parts Inspection - Suzuki RMX450Z Service Manual

Installation
1) Install the spacers (1).
1
2) Remount the rear wheel and rear axle, tighten the
rear axle nut (2) temporarily.
3) Adjust the chain slack after installing the rear wheel.
Refer to "Drive Chain Inspection and Adjustment" in
Section 0B (Page 0B-20).
4) Tighten the rear axle nut (2) to the specified torque.
Tightening torque
Rear axle nut (a): 100 N·m (10.0 kgf-m, 72.5 lbf-
ft)
WARNING
!
After remounting the rear wheel, pump the
brake pedal several times to check for proper
brake operation.
5) Tighten both chain adjuster lock nuts (3) securely.

Rear Wheel Related Parts Inspection

Refer to "Rear Wheel Assembly Removal and
Installation" (Page 2D-11).
Tire
Refer to "Wheel and Tire Inspection" in Section 0B
(Page 0B-24).
Rear Brake Disc
Refer to "Rear Brake Disc Inspection" in Section 4C
(Page 4C-6).
1
IA02J1240005-02
3
2
(a)
IA02J1240006-02
BA02J22406010
Sprocket
Refer to "Drive Chain Related Components" in Section
3A (Page 3A-2).
Spoke Nipple and Rim Lock
Refer to "Wheel and Tire Inspection" in Section 0B
(Page 0B-24).
Dust Seal
Inspect the each dust seal lip for wear or damage. If any
defects are found, replace the dust seal with a new one.
Refer to "Rear Wheel Dust Seal / Bearing Removal and
Installation" (Page 2D-13).
Wheel Axle
Using a dial gauge, check the wheel axle for runout, If
the runout exceeds the limit, replace the axle shaft.
Wheel axle runout
Service limit: 0.25 mm (0.010 in)
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100 mm))
(A)
(C)
Wheels and Tires: 2D-12
IA02J1240007-01
(B)
IA02J1230096-01