Table of Contents
Advertisement
Pin
#
1
2
3
4
5
6
7
8
9
2.1.5. Power Connections
The Upconverter has one or two (redundant supply is optional) universal power supplies that operate on
either 115 Volt / 60 Hz or 230 Volt / 50 Hz AC.
2.1.6. Composite Decoder Video In And Out
ANALOG IN This BNC connector is for connecting a source of composite analog NTSC video. The input
is internally terminated with 75 ohms.
SDI OUT This BNC connector contains decoded video with embedded group 1 audio in the SMPTE
259M-C standard. This output is normally connected to the SDI IN connector on the main part
of the Upconverter.
REF IN
This BNC connector is for connecting a reference black signal to properly time the decoded
output video. The input is internally terminated with 75 ohms.
2.1.7. Composite Decoder Audio In And Out
ANALOG INPUT 1 to 4
and embedded on the SDI output video. It is also available as AES audio on two separate
outputs.
AES OUTPUT 1
AES audio output from channels 1 and 2.
Upconverter application but can be used to provide AES audio to other devices in the plant.
AES OUTPUT 2
AES audio output from channels 3 and 4.
Upconverter application but can be used to provide AES audio to other devices in the plant.
INSTALLATION
HD9510UC High Definition Upconverter Manual
Name
GPI1
Recall Preset 1
GPI2
Recall Preset 2
GPI3
Recall Preset 3
GPI4
Recall Preset 4
GPI5
General Purpose input – future use
GPI6
General Purpose input – future use
GPI7
General Purpose input – future use
Gnd
Ground
V Ext
External Reference voltage
Table 2-3: GPI/O Port Pin Definitions
Balanced Analog audio input for channels 1 to 4. This audio will be digitized
Description
This output is not required for the
This output is not required for the
Revision 1.1.1
Page 2-3
Advertisement
Table of Contents
