Table of Contents
Advertisement
2.1.7. Parallel Remote Control Connections
PARALLEL: A 9 pin D connector located on the rear panel labeled PARALLEL provides control
inputs and outputs for remote control of some of the model 8010TM functions. There
are also two open collector outputs that can be assigned to a variety of functions. When
the 8010TM is operating in the time rctl mode, the functions of these I/O pins is
reassigned to provide a method of inputting Remote Control information and encoding it
into the user bits. See section 2.6 for information on connecting the parallel inputs and
outputs. See sections 3.7.9.2 to 3.7.9.5 for a complete description of the operation of
the normal Parallel I/O functions. The pinout of the PARALLEL connector when the
GEN MODE is NOT set to time rctl mode is as follows:
Pin #
1
2
3
4
5
6
7
8
9
Table 2-3: Parallel Port Pin Definitions – Normal GPIO Functions
See section 3.7.9.1 for a complete description of the operation of the time rctl mode.
The pinout of the PARALLEL connector when the GEN MODE is set to time rctl mode is
as follows:
Pin #
1
2
3
4
5
6
7
8
9
Table 2-4: Parallel Port Pin Definitions – Time RCTL Mode
2.1.8. Power Connections
LINE:
The 8010TM has a universal power supply operating on 100 to 240v, 60 or 50 Hz AC.
Dual supply versions have an identical redundant supply.
INSTALLATION
Model 8010TM SDI Time Code Master Manual
Name
Description
GPO 1
General Purpose Output 1
GPO 2
General Purpose Output 2
GPI 1
General Purpose Input 1
GPI 2
General Purpose Input 2
JAM Ena
Jam Sync enable (8010TM)
Bypass
Enable Bypass Relay
VCG Ena
VCG On/Off
VITC Ena
VITC generator enable
GND
Frame ground
Name
Description
RCTL 1
Controls UB GPI bit 1
RCTL 2
Controls UB GPI bit 2
RCTL 3
Controls UB GPI bit 3
RCTL 4
Controls UB GPI bit 4
RCTL 5
Controls UB GPI bit 5
Bypass
Enable Bypass Relay
RCTL 6
Controls UB GPI bit 6
VITC Ena
VITC generator enable
GND
Frame ground
Revision 1.5.1
Page 2-3
Advertisement
Table of Contents
