Table of Contents
Advertisement
2.3.
VIDEO INPUT CONNECTION
Connect the HD INPUT BNC connector on the A-2410MD adapter to the HDSDI Video output from the
camera. The A-2410MD adapter supports the video formats shown in Table 2.
2.4.
VIDEO OUTPUT CONNECTIONS
The A-2410MD provides downconverted outputs in serial digital and analog formats. Table 2 shows the
downconverter output formats for each video format.
The two SDI OUTPUT BNC connectors are used to output the downconverted video as serial component
video, compatible with the SMPTE 259M standard.
The two ANALOG OUTPUT BNC connectors are used to output the downconverted video from the
camera as NTSC/PAL analog composite video.
2.5.
POWER CONNECTIONS
Power is provided to the A-2410MD from the camera battery or through the 4 pin male XLR EXT DC
connector. Apply +12VDC to pin 4 and ground to pin 1 of the XLR.
There is a power switch on the front panel. Press this switch to the ON position to provide power to the
unit. Power supplied from the battery or through the EXT DC connector is also passed through to the
camera regardless of when the power switch in the On position.
3.
SPECIFICATIONS
3.1.
VIDEO INPUT
Standard:
1.485 Gb/s SMPTE 292M – autodetect
All standards supported in AJ-HDC20A and AJ-HDC27V cameras (See Table 2). Video
standard is auto detected
Connector:
1 BNC per IEC 169-8
3.2.
SDI SERIAL VIDEO OUTPUTS
Standards:
Connectors:
Signal Level:
DC Offset:
Rise and Fall Time: 470ps nominal
Overshoot:
Return Loss:
Wide Band Jitter:
Serial Component 270 Mb/s (SMPTE 259M-C)
2 BNC per IEC 169-8
800mV nominal
0V ±0.5V
<10% of amplitude
> 15 dB
< 0.2 UI
A-2410MD Monitoring Down Converter Manual
Revision 1.1
A-2410MD-4
Advertisement
Table of Contents
