Table of Contents
Advertisement
2.2
MOUNTING
INSTALLATION
8083XDS-AD Analog and SD-SDI XDS Encoder
PORT B, C: These 9 pin male 'D' connectors may be used for connection
to computers with XDS control software. The front panel
Engineering menus are used to set the correct baud rate, word
size and parity for use with your captioning software.
section 3.3)
The pinout of this connector is designed so that you can use a
readily available "null modem" cable to connect to your
computer. Please refer to Figure 2-4 and Figure 2-5 for typical
port pinouts and connections to a computer.
2.1.4
Parallel Remote Control Connections
PARALLEL: A 9-pin female 'D' connector for connection to 'closure to
ground' remote control signals. Each input is optically isolated,
and has an internal 47 K ohm pull-up to +5 volts. The pinout of
the connector is as follows:
Pin
1
2
3
4
5
6
7
8
9
Figure 2-2: Parallel GPI Port Pinout
Refer to section 3.5 for details on the functions of each parallel
port GPI pin.
2.1.5
Power Connections
LINE:
The XDS Encoder has one or two universal power supplies that
operate on either 115v/60 Hz or 230v/50 Hz AC operation.
(Redundant supply is optional). The power supplies auto sense
the input mains voltage.
The XDS Encoder is equipped with rack mounting angles and fits into a
standard 19 inch by 1 3/4 inch (483 mm x 45 mm) rack space.
mounting angles may be removed if rack mounting is not desired.
Revision 1.0.2
Description
Ground
Serial Port A Disable
Serial Port B Disable
Serial Port C Disable
Not used
Bypass Relay Enable
Caption Keyer Disable
Caption Shift Up
Ground
(See
The
Page 2-3
Advertisement
Table of Contents
